Skip to content Skip to sidebar Skip to footer

irc 58 2012 code book pdf download

Abstract

Design of concrete pavements is carried out with the help of available guidelines that are generally based on single size of slab panel. However, in practice, the slab size is seen to be different than the one recommended by most of the guidelines such as PCA (Thickness design for concrete highway and street pavements, Portland Cement Assosiation, Skokie, 1984) and IRC 58 (Guidelines for the design of plain jointed rigid pavements for highways, 4th Revision, Indian Road Congress, New Delhi, 2015) , especially on curves or at the junctions. It is also established that temperature stresses vary with the plan size of the panel. The important parameter in the design of concrete pavement is critical edge stress which depends on traffic and temperature load. However, it is observed that, for the same design parameters such as traffic load and subgrade stiffness of soil, critical stress values alter largely as the panel size is diverse from the standard one. The standard panel size as specified by PCA (1984) and IRC 58 (2015) is 3.5 m \(\times \) 4.5 m. In this paper, the effect of the size of slab panel and radius of relative stiffness on critical edge stress has been investigated. Analytical models have been developed to obtain critical edge stress for concrete pavement resting on an elastic soil foundation using finite element software. It has been found that, for smaller panel sizes with low radius of relative stiffness, critical stresses obtained are higher. Therefore, it is necessary to consider the effect of the size of slab panel and radius of relative stiffness, while designing the concrete pavement.

References

  1. 1.

    Dekate, M.N.; Pajgade, P.S.: Bituminous versus cement concrete roads. Indian concrete institute. Indian concrete institute 17(2), 38–41 (2016)

  2. 2.

    Huang, Y.H.: Pavement Analysis and Design, 2nd edn. Pearson Prentice Hall, Upper Saddle River, New Jersey (2004)

    Google Scholar

  3. 3.

    Packard, R.G.: Thickness Design for Concrete Highway and Street Pavements. Portland Cement Assosiation, Skokie (1984)

    Google Scholar

  4. 4.

    IRC 58. Guidelines for the design of plain jointed rigid pavements for highways. 4th Revision, Indian Road Congress. New Delhi, India, (2015)

  5. 5.

    IRC 58. Guidelines for the design of plain jointed rigid pavements for highways. 3rd Revision. Indian Road Congress, New Delhi (2011)

  6. 6.

    Mathew, T.V.; Rao, K.V.K.: Introduction to transportation engineering. NPTEL, Chapter 29, 29.1-29.9 (2007). http://nptel.ac.in/courses/105101087/downloads/Lec-29.pdf Accessed 07 Sept 2017

  7. 7.

    Riad, M.Y.; Shoukry, S.N.; William, G.W.; Rao-Hejamadi, D.: Curling of concrete slabs on grade: experimental versus theoretical analysis. Struct. Infrastruct. Eng. 4(1), 57–72 (2008)

    Article  Google Scholar

  8. 8.

    Yoder, E.J.; Witczak, M.W.: Principles of Pavement Design, 2nd edn. Wiley India Pvt. Ltd., Delhi (2012)

    Google Scholar

  9. 9.

    Das, A.: Analysis of Pavement Structures. CRC Press, Taylor and Francis, Boca Raton (2014)

    Book  Google Scholar

  10. 10.

    Choubane, B.; Tia, M.: Analysis and verification of thermal-gradient effects on concrete pavement. J. Transp. Eng. 121(1), 75–81 (1995). https://doi.org/10.1061/(ASCE)0733-947X(1995)121:1(75)

    Article  Google Scholar

  11. 11.

    Maitra, S.R.; Reddy, K.S.; Ramachandra, L.S.: Estimation of critical stress in jointed concrete pavement. Procedia Soc. Behav. Sci. 104, 208–217 (2013)

    Article  Google Scholar

  12. 12.

    Mackiewicz, P.: Thermal stress analysis of jointed plane in concrete pavements. Appl. Therm. Eng. 73(1), 1167–1174 (2014)

    Article  Google Scholar

  13. 13.

    IRC 15. Standard specifications and code of practice for construction of concrete roads. 4th Revision. Indian Road Congress, New Delhi (2011)

  14. 14.

    Bester, J.J.; Kruger, D.; Hinks, A.: AASHTO Guide for Design of Pavement Structures. AASHTO (1993)

  15. 15.

    Westergaard, H.M.: Stresses in concrete pavements computed by theoretical analysis. Public Roads Federal Highw. Adm. 7(2), 25–35 (1926)

    Google Scholar

  16. 16.

    IRC 58: Guidelines for the design of plain jointed rigid pavements for highways. 2nd Revision. Indian Road Congress, New Delhi (2002)

  17. 17.

    IRC 58: Guidelines for the design of rigid pavements for highways. Indian Road Congress, New Delhi (1974)

  18. 18.

    Roesler, J.R.; Cervantes, V.G.; Amirkhanian, A.N.: Accelerated performance testing of concrete pavement with short slabs. Int. J. Pavement Eng. 13(6), 494–507 (2012). https://doi.org/10.1080/10298436.2011.575134

    Article  Google Scholar

  19. 19.

    Heinrichs, K.W.; Liu, M.J.; Darter, M.I.; Carpenter, S.H.; Ioannides, A.M.: Rigid pavement analysis and design. Report No. FHWA-RD-88-068, Final report. Phase-I, U.S. Department of transportation, Federal highway administration, Washington, DC (1989)

  20. 20.

    Oh, H.J.; Kim, S.M.; Chung, W.; Lee, Y.H.; Cho, Y.K.: Effect of joint type on rigid airfield pavement behavior. KSCE J. Civ. Eng. 18(5), 1389–1396 (2014). https://doi.org/10.1007/s12205-014-0532-0

    Article  Google Scholar

  21. 21.

    Maitra, S.R.; Reddy, K.S.; Ramachandra, L.S.: Load transfer characteristics of aggregate interlocking in concrete pavement. J. Transp. Eng. 136(3), 190–195 (2010). https://doi.org/10.1061/(ASCE)TE.1943-5436.114

    Article  Google Scholar

  22. 22.

    Lee, Y.H.; Carpenter, S.H.: PCAWIN program for jointed concrete pavement design. Tamkang J. Sci. Eng. 4(4), 293–300 (2001)

    Google Scholar

  23. 23.

    Lee, Y.H.; Darter, M.I.: Loading and curling stress models for concrete pavement design. Transp. Res. Rec. 1449, 101–112 (1994)

    Google Scholar

  24. 24.

    Yang, Q.; Dai, J.: Effects of traffic characteristics on pavement responses at the road intersection. Struct. Eng. Mech. 47(4), 531–544 (2013). https://doi.org/10.12989/sem.2013.47.4.531

    Article  Google Scholar

  25. 25.

    Shoukry, S.N.; Fahmy, M.; Prucz, J.; William, G.: Validation of 3DFE analysis of rigid pavement dynamic response to moving traffic and nonlinear temperature gradient effects. Int. J. Geomech. 7(1), 16–24 (2007). https://doi.org/10.1061/(ASCE)1532-3641(2007)7:1(16)

    Article  Google Scholar

  26. 26.

    Blaauwendraad, J.: Plates and FEM - Surprises and Pitfalls. Solid Mechanics and Its Applications, vol. 171. Springer, Dordrecht (2010)

    MATH  Google Scholar

  27. 27.

    Vishwakarma, R.J.; Ingle, R.K.: Simplified approach for the evaluation of critical stresses in concrete pavement. Struct. Eng. Mech. 61(3), 389–396 (2017). https://doi.org/10.12989/sem.2017.61.3.389

    Article  Google Scholar

  28. 28.

    Sabih, G.; Tarefder, R.A.: Impact of variability of mechanical and thermal properties of concrete on predicted performance of jointed plain concrete pavements. Int. J. Pavement Res. Technol. 9(6), 436–444 (2016). https://doi.org/10.1016/j.ijprt.2016.09.005

    Article  Google Scholar

  29. 29.

    ABAQUS User's Manual, Version 6.13-1, Dassault Systèmes Simulia Corp., Providence, RI, USA (2013)

  30. 30.

    Maitra, S.R.; Reddy, K.S.; Ramachandra, L.S.: Numerical investigation of fatigue characteristics of concrete pavement. Int. J. Fract. 189(2), 181–193 (2014). https://doi.org/10.1007/s10704-014-9969-x

    Article  Google Scholar

  31. 31.

    Vishwakarma, R.J.; Ingle, R.K.: Evaluation of subgrade strength of soil below concrete pavement using non-destructive method. In: Proceeding, Conference on Numerical Modeling in Geomechanics. CoNMiG-2017, Roorkee, India, 21–26 (2017)

  32. 32.

    Wang, Y.H.; Tham, L.G.; Cheung, Y.K.: Beams and plates on elastic foundations: A review. Prog. Struct. Eng. Mater. (2005). https://doi.org/10.1002/pse.202

    Google Scholar

  33. 33.

    Godbole, P.N.: Introduction to Finite Element Methods, 1st edn. I.K. International Publishing House, New Delhi (2013)

    Google Scholar

  34. 34.

    Chattaraj, R.; Pandey, B.B.: Short panelled concrete pavement in built-up area. Indian Highw. Indian Road Congr. India 42(1), 5–12 (2014)

    Google Scholar

Download references

Author information

Affiliations

  1. Department of Applied Mechanics, Visvesvaraya National Institute of Technology, South Ambazari Road, Abhyankar Nagar, Nagpur, Maharashtra, 440010, India

    Rameshwar J. Vishwakarma & Ramakant K. Ingle

Corresponding author

Correspondence to Rameshwar J. Vishwakarma.

About this article

Verify currency and authenticity via CrossMark

Cite this article

Vishwakarma, R.J., Ingle, R.K. Effect of Panel Size and Radius of Relative Stiffness on Critical Stresses in Concrete Pavement. Arab J Sci Eng 43, 5677–5687 (2018). https://doi.org/10.1007/s13369-018-3308-x

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI : https://doi.org/10.1007/s13369-018-3308-x

Keywords

  • Concrete pavement
  • Edge stress
  • Slab thickness
  • Radius of relative stiffness
  • Soil structure interaction
  • Simplified approach

Source: https://link.springer.com/article/10.1007/s13369-018-3308-x

Posted by: isaiahisaiahminzenbergere0270761.blogspot.com

Post a Comment for "irc 58 2012 code book pdf download"